Chameleon Plug & Play CMM Motion Controller
CMM Retrofits allow you to upgrade your CMM hardware with the latest advancements in measurement technology, ultimately improving your accuracy, efficiency, and machine life. However, many discontinued CMM controllers can no longer communicate with modern CMM software. In other cases, the CMM controller might need repair, however, replacement parts are often nonexistent. That’s where the Chameleon CMM Controller from Easy CMM comes in!
Capable of working with virtually any combination of CMM hardware and CMM software, the Chameleon is the most flexible CMM retrofit controller ever produced. Whether you want to use your old CMM software on a different machine, or if you want to use modern software to revive your old machine, the Chameleon CMM motion controller is the plug & play solution you need.
The Chameleon controller works by emulating the original CMM controller, allowing your CMM to run off of any modern software. So no matter what CMM software your team uses, your Chameleon controller will enable your aging CMM to run your programs.
Whether you want to breathe new life into a CMM with obsolete tech, utilize your team’s current CMM programs on an updated system, or tackle any other retrofit compatibility complication, the Chameleon Controller from Easy CMM is what you’ve been looking for!
Streamline Your CMM Retrofit
With the Chameleon Motion Controller, a CMM retrofit goes from a thorough restoration project to a simple hardware upgrade–saving you time and money instantly. And because you can keep using your original CMM programs, you can start measuring parts almost immediately!
Revive Your CMM With Made to Measure & EasyCMM
Are you wondering if the Chameleon controller can breathe new life into your obsolete CMM? Made to Measure is ready to help you find out! Whether you own Mitutoyo CMM that’s been out of commission for years, an LK that’s not OK, an aging Brown & Sharpe, or if you just don’t know how to get your CMM working with whatever equipment you have on-hand, the Chameleon is ready to take on the challenge. Get in touch with our team at Made to Measure to see how a retrofit with the EasyCMM Chameleon can make the most of your machine.
"We manufacture aftermarket turbine engine aerospace parts. We not only use our CMMs for inspecting the very tight tolerance that we have to produce with our parts, but we also rely on them to reverse engineer OEM parts to manufacture. The AUKOM training we received at Made to Measure has helped our engineering staff understand how to get the correct results from our CMM for what we are trying to achieve. The training has also helped our quality staff understand how to inspect and evaluate results properly to meet the requirements of the print. The staff at Made to Measure are extremely knowledgeable and the training was very well presented."
Bryan S. Aerospace Parts Manufacturer, AUKOM Level 1 Certified
“I couldn’t be happier with [Made to Measure]. They do great work for us.”
Sr., Molding Engineer, Commscope
“Learning the different ways that a CMM evaluates features on a part; least squares, minimum zone, max inscribed, and min circumscribed; and when to use which evaluation, has made a huge difference in the accuracy of our CMM programs after going through the AUKOM courses . Our CMM programs are now much more repeatable between users and even locations across the globe (China)”
Joe B. QA Supervisor, Gear & Engineering Corp.
"Thank you for the fine and fast work of all involved at Made to Measure to create this cap model. The model helped us create a new model and reproduce a new mold that is now producing parts locally."
J.H. Engineering Manager, Zeller Plastics
“We used to do everything in-house….but now that we‘re getting skinnied down to the point where you don’t have time to do it, we sought an outside service bureau. I couldn’t be happier with Made to Measure. They do great work for us.”
J.M., Sr. Molding Engineer
“Has anyone told you guys you’re awesome lately? The Made to Measure team makes it a pleasurable business experience.”
Christine R., Division Supplier Development
"You guys do great work. I’m glad I can recommend one of our good customers to you"
Local Tool & Die Manufacturer